The Parker Watts FluidAir R216-02E (Parker FRL) is an industrial-grade precision pneumatic pressure regulator engineered for highly accurate low-pressure air regulation. Equipped with a USG (U.S. Gauge) 0–5 psi test gauge indicates a specialized setup optimized for fine-tuning ultra-low pressure environments, such as leak detection, precise calibration, or sensitive diagnostic testing.
• Port / Pipe Size: 1/4" NPT (Inlet/Outlet)
• Gauge Port: 1 x 1/8" NPT
• Standard Reduced Pressure Range: 0 to 8 psi (or 0 to 0.6 bar)
• Maximum Inlet Pressure: 300 psi
• Maximum Flow Rate: 40 SCFM
While the R216-02E regulator mechanism internally drops incoming line pressures down to a maximum range of 0–8 psi, pairing it with a specialized 0–5 psi U.S. Gauge transforms it into a high-visibility test station. Dial Resolution: A 0–5 psi scale spans a standard gauge face much wider than a typical 0–160 psi gauge. This makes increments as small as 0.1 psi easily readable. The gauge maxes out at 5 psi. Turning the t-handle past the gauge's 5 psi threshold will over-pressurize, peg, or permanently damage the internal bourdon tube of the test gauge.
• Port / Pipe Size: 1/4" NPT (Inlet/Outlet)
• Gauge Port: 1 x 1/8" NPT
• Standard Reduced Pressure Range: 0 to 8 psi (or 0 to 0.6 bar)
• Maximum Inlet Pressure: 300 psi
• Maximum Flow Rate: 40 SCFM
While the R216-02E regulator mechanism internally drops incoming line pressures down to a maximum range of 0–8 psi, pairing it with a specialized 0–5 psi U.S. Gauge transforms it into a high-visibility test station. Dial Resolution: A 0–5 psi scale spans a standard gauge face much wider than a typical 0–160 psi gauge. This makes increments as small as 0.1 psi easily readable. The gauge maxes out at 5 psi. Turning the t-handle past the gauge's 5 psi threshold will over-pressurize, peg, or permanently damage the internal bourdon tube of the test gauge.

