MirraChrome will create a mirror finish as long as your surface is as smooth as glass. Please follow these steps for best results. If your surface already has a glass like sheen, move on to step 4.

STEP 1. - Apply Alsa Jet Black Stylin Basecoat over your primer.

STEP 2. - Allow the basecoat to fully dry 15-30 min. You are now ready to apply 1-2 coats of Mirra Clear.

STEP 3. - Allow the Mirra Clear (do not bake) to air dry 24 hours.

STEP 4. - Begin applying MirraChrome using a dusting effect, (very small volume of material with a substantial amount of air). INSTRUCTIONS: If you are using an H.V.L.P. gun you should be around 20 p.s.i. otherwise use whatever the recommended air pressure is for your gun, remembering to keep the material volume very low. Continue applying the MirraChrome until desired effect is achieved.

STEP 5. - Allow the MirraChrome to air dry four to 24 hours (70º - 75º F); do not bake.

STEP 6. - Use a very soft lint-free cloth to remove any of the excess dust/overspray from the surface; wipe softly. If you complete this step you will notice a drastic improvement in the final appearance.

STEP 7. - Now apply 1 coat MirraClear and allow to dry for 30 min air dry (15 min@140°F) before moving on to Step 8.

STEP 8. - If you are applying this to a vehicle or other object that will be handled frequently or exposed to the elements you will now want to apply the Alsa Speed Clear (wet sand the Mirra Clear beforehand).